Electronic Component

PWM controller – TL494

Posted by joey899244 in 29/11/2012

The circuit consists of three parts, power supply, TL494 itself and totem-pole MOSFET drivers. I had an old power brick labeled as 12 VAC 600 mA, but it’s RMS and probably a bit higher, it gives steady 16 VDC after rectification with 1 mF filtering capacitor and under about 200 mA load, I have yet to fully test it. Standard LM317T circuit (note wrong pinout in the KiCAD library symbol!) straight from the datasheet powers totem-pole drivers with the RV1 potentiometer adjusting it up to just under 14 V counting the dropout, which is more than enough to test most MOSFETs. Small LM78L05 (L indicates a TO-92, 100 mA version) powers TL494, this way changing the amplitude does not affect frequency and duty cycle. It’s under recommended 7 V for TL494 supply, but it works and I only had this regulator other than another beefy TO220 LM317 in my parts bin.

On the actual IC there’s nothing complicated. The combination of 680 pF cap and 1M RV3 pot gives (at 5 volts I tested it) output frequency from about 2.5 kHz up to unde 100 kHz. Switch controls channel behaviour, they can work in parallel (turning on and off at the same time) or alternating (when one channel is on then the other is off). RV2 pot adjusts duty cycle, you can adjust it from about 2-5% up to 100% (continuosly on). This chip also has error amplifiers and 5 V reference source, because it’s really a switchmode power supply controller, but they’re not used here.

On the output there are two channels with a totem-pole transistor configuration each. The additional NPNs are there so it doesn’t invert the input from TL494.

No Responses

Leave a Reply

Categories

Calendar

November 2012
M T W T F S S
    Dec »
 1234
567891011
12131415161718
19202122232425
2627282930